#Sentry safe open instruction manual

NOTE: See the sticker on the back cover of this manual for your combination. Lock instructions Gaining Entry into Safes with Combination Locksģ-Number Combination Lock and Dual Combination Key Lock NOTE: SentrySafe is not responsible for any costs incurred if unit is to be replaced.

#Sentry safe open instruction install

Place the rubber side of the washer facing down against the safe floor and install the fastener. Assure that the area around the safe hole opening is clean using a damp cloth. If a water resistant unit was purchased, rubberized washers are provided. Place the safe back over the holes and install the fasteners as required.

Move the safe away and drill holes of the appropriate diameter and depth for the type of hardware and the mounting surface being used (2 each – bolts, washers and masonry anchors).

Note: Fire-Safe models cannot be bolted to the wall. If bolting to a wall, please ensure that the safe is resting firmly on the floor. It is not recommended to attempt to bolt to both floor and wall. Set the safe in place and use the holes provided in the bottom or back of the safe to mark the location of the holes to be drilled in the floor or wall.

Select a suitable and convenient location for your safe.

To help provide maximum security, SentrySafe strongly recommends this safe be bolted down.

Remove the pallet and stand the safe upright on the floor.

Tip the safe so that the edge moves to the floor.

With your helper, slide safe to one edge of pallet.

Close door and put handle in locked position.

Once the nuts are removed, use a hammer to tap the bolts through the bottom of the safe.

NOTE: If the bolts turn when you begin to remove the nuts, reach between the slats of the pallet and hold the bolts, by hand and/or with pliers, as you turn the nuts.

Using a wrench or pliers, remove the nuts located under the X-cut in the carpet in the bottom of the unit.

Adjustable wrench, pliers, or 17 mm (11/16”) socket wrench.

NOTE: Sentry Group is not responsible for any costs incurred for unit to be removed from pallet and installed in place. Ensure the safe is standing upright on a flat, level surface. Before attempting to unbolt your new safe, be certain someone is with you to help steady the safe while you work. This is a two-person operation and should not be attempted without help. WARNING! UNBOLTING YOUR GUN SAFE FROM THE SHIPPING PALLET! Unbolting your gun safe from the shipping pallet Customer Service representatives are ready to assist you, 8 a.m. If you have any questions about your gun safe, please visit our website at or call Sentry Customer Service at 1-80 or 1-58. Please retain this manual for your records. Writing down a combination and putting it in a desk drawer is like leaving your door key under the mat – it invites entry. Remember to keep your combination a secret.

#Sentry safe open instruction full

take full advantage of your safe’s special features.